Seagate Barracuda ES.2
- Advanced Replacements
- Online Warranty Checker
- Online RMA Request
Seagate Barracuda ES.2
Midline 3Gbps SATA II Disk Drive for entry level servers and SANs.
SN06 Firmware Update |
| When buying an ST31000340NS, ST3750330NS, or ST3500320NS disk drive, be sure to request units with SN06 or later firmware. Early firmware revisions had a problem where SMART counters would exceed a Seagate defined threshold upon startup. The drive would then lock into a BSY state where data would be protected, but be inaccessible except by a trained data recovery professional. Note this is not a SMART TRIP, but rather, an event counter overflow. |
Avoid New Bulk and New Pulls |
| The Seagate Barracuda ES.2 was released in 2008 and production ran until the end of 2010. The series was replaced by the Seagate Constellation ES. Beware of merchants selling ST31000340NS, ST3750330NS, or ST3500320NS drives as “new bulk” or “new pulls.” When buying any SATA drive that is not factory sealed, be sure to ask the vendor about the drive SMART statistics. Observe all the failure points monitored by SMART in the image below. The drive we tested was advertised as “new bulk” when, clearly, it has been used extensively.
|
What to expect from an iStorage Networks Disk Drive |
| iStorage Networks verifies that every drive we ship is either new (as identified by the number of power on hours being less than 5) or being a qualified refurbished unit. All our drives will ship with the latest firmware revision and will never have any reallocated sectors (aka grown defects) or sectors pending reallocation. Grown defects are the number one indicator of a failing disk drive (see a great Google case study here.)
iStorage Networks will never ship a disk drive with any SMART parameter out of Seagate specification. ‘
|

